============================================================= rpc00050: *Arabidopsis thaliana* YG1 cell suspension culture ============================================================= :download:`Download a PDF version (143 KB) <../cell_lines/rpc00050_YG1_3_2.pdf>` .. note:: * Components * Domestic delivery: A 50-mL plastic conical centrifuge tube, containing cell suspension * Overseas delivery: A 250-mL plastic Erlenmeyer flask, containing cells placed on semi-solid medium * Notice * Subculture the cells to fresh medium immediately after arrival. * Do not store the cell culture in a refrigerator and a freezer. * Maintain aseptic conditions of the cell culture, and work in a laminar flow cabinet. * Method * Culture medium: mLS medium, 0.2 mg/L 2,4-D, pH 5.8 (\ :doc:`medium no. 1 `\ ) * Culture conditions: 27°C, dark, 130 rpm * Subculture: 7-day intervals * Citation of cell line When results obtained by using this cell line are published in a scientific journal, it should be cited in the following manner: “*Arabidopsis thaliana* YG1 cell line (rpc00050) was provided by the RIKEN BRC through the National BioResource Project of the MEXT, Japan.” Introduction ============= Arabidopsis YG1 cell line was established from a seedling of *Arabidopsis thaliana* (L.) Heynh. accession Columbia (Nishikiori *et al*. 2011 [1]_, Yoshikawa *et al*. 2021 [2]_). The YG1 cells are grown in a modified Linsmaier and Skoog (mLS) medium supplemented with 0.2 mg/L 2,4-dichlorophenoxyacetic acid (2,4-D), pH 5.8. Our YG1 cell culture has been maintained in the dark at 27°C with rotary shaking at 130 rpm and subcultured at 7-day intervals. Materials ========== Chemicals and stock solutions ------------------------------ (All stock solutions are stored at 4°C) * MS salt mix Murashige and Skoog Plant Salt Mixture, FUJIFILM Wako Pure Chemical Corporation (#392-00591) * Sucrose * BY2_P .. csv-table:: :header: "Chemical", "Concentration (mg/mL)" :widths: auto "KH\ :sub:`2`\ PO\ :sub:`4`", "80" * LS_VT_modified .. csv-table:: :header: "Chemical", "Concentration (mg/mL)" :widths: auto "Thiamine·HCl", "0.4" "*myo*-Inositol", "40" * 2,4-D (0.2 mg/mL) .. csv-table:: :header: "Chemical", "Concentration (mg/mL)" :widths: auto "2,4-D sodium monohydrate", "0.236" (2,4-Dichlorophenoxy)acetic acid sodium salt monohydrate, Sigma-Aldrich (D6679) * KOH (1 N) Glassware ---------- * Erlenmeyer flask (300 mL), capped with two layers of aluminum foil * Pipette (10 mL; large tip opening) and a bulb, sterilized by autoclaving at 121°C for 20 min Preparation of mLS medium (medium no. 1) ----------------------------------------- :doc:`/media/medium_1` #. Dissolve the following chemicals in approximately 800 mL of distilled water. .. csv-table:: :header: "Chemical", "Amount" :widths: auto "MS salt mix", "1 bag (1 L)" "Sucrose", "30 g" #. Add following stock solutions, and fill up to approximately 950 mL with distilled water. .. csv-table:: :header: "Stock solution", "Volume (mL)" :widths: auto "BY2_P", "2.5" "LS_VT_modified", "2.5" "2,4-D (0.2 mg/mL)", "1" #. Adjust the pH of the solution to 5.8 with KOH (1 N), and fill up to 1 L with distilled water. #. Pour 80 mL of the medium into a 300-mL flask. #. Autoclave the flask at 121°C for 20 min. Methods ======== #. Leave to stand a flask containing a 7-day-old culture until the cells settle to the bottom of the flask. #. Transfer 4--6 mL of the sedimented cells to 80 mL of fresh mLS medium with a pipette. #. Incubate cell cultures on a rotary shaker at 130 rpm under the dark condition at 27°C. Notes ====== * For domestic customers: We send YG1 cell suspension in a 50-mL disposable conical centrifuge tube. The cells should be transferred to fresh mLS medium immediately after arrival. * For overseas customers: We send YG1 cells placed on semi-solid mLS medium in a 250-mL disposable Erlenmeyer flask. The cells should be transferred to fresh mLS medium immediately after arrival. Collect the cells from the semi-solid medium with a spatula and transfer them to Erlenmeyer flasks containing fresh liquid medium. * In order to maintain YG1 cell suspension cultures stably, it is essential to transfer an adequate amount of cells to fresh mLS medium in every subculture. The amount of cells may vary from one lab to another, because proliferation of YG1 cells is affected by culture conditions, such as a room temperature, rotation speed of a rotary shaker, and aeration condition of the culture. * In order to obtain good aeration of a suspension culture, a silicone sponge plug may be used instead of the aluminum foil cap (*e.g.*, `cap-type Silicosen `_\ ; Shin-Etsu Polymer, Tokyo, Japan). Genotyping =========== :doc:`/genotyping/g_rpc00050` Maintenance history ==================== :doc:`/maintenance/m_rpc00050` References =========== .. [1] Nishikiori M, Mori M, Dohi K, Okamura H, Katoh E, Naito S, Meshi T, Ishikawa M (2011) A host small GTP-binding protein ARL8 plays crucial roles in tobamovirus RNA replication. PLoS Pathogen 7: e1002409. DOI: `10.1371/journal.ppat.1002409 `_ .. [2] Yoshikawa M, Han Y-W, Fujii H, Aizawa S, Nishino T, Ishikawa M (2021) Cooperative recruitment of RDR6 by SGS3 and SDE5 during small interfering RNA amplification in *Arabidopsis*. Proceedings of National Academy of Sciences of USA 118: e2102885118. DOI: `10.1073/pnas.2102885118 `_ Protocols ========== * Genotyping of plant cell lines: :doc:`/protocols/genotyping/arabidopsis` External links =============== * `World Flora Online: Arabidopsis thaliana (L.) Heynh. `_ * `Wikipedia: Arabidopsis thaliana `_ .. index:: single: Arabidopsis thaliana single: YG1